Corrected comments that didn't convert well automatically and caused syntax errors.

bacnet-stack/ports/pic18f6720/rs485.c

@@ -43,7 +43,8 @@ uint32_t RS485_Baud_Rate = 9600;
 /* the ISR and other use this for status and control */
 COMSTAT RS485_Comstat;
 
-/*#pragma udata MSTPPortData
+/*#pragma udata MSTPPortData
+ */
 /* the buffer for receiving characters */
 volatile uint8_t RS485_Rx_Buffer[MAX_MPDU];
 
@@ -86,14 +87,15 @@ void RS485_Send_Frame(volatile struct mstp_port_struct_t *mstp_port,    /* port
     };
 
     RS485_Comstat.TxHead = 0;
-    RS485_Comstat.TxHead = 0;
-    memcpy((void *) &RS485_Tx_Buffer[0], (void *) buffer, nbytes);
-
-    /*for (i = 0; i < nbytes; i++) {
- */
-    /*  /* put the data into the buffer */ 
-*/
-        /*  RS485_Tx_Buffer[i] = *buffer;
+    memcpy((void *) &RS485_Tx_Buffer[0], (void *) buffer, nbytes);
+    #if 0
+    for (i = 0; i < nbytes; i++) {
+        /* put the data into the buffer */ 
+        RS485_Tx_Buffer[i] = *buffer;
+        buffer++;
+    }
+    #endif
+    RS485_Comstat.Tx_Bytes = nbytes;
     /* disable the receiver */
     PIE3bits.RC2IE = 0;
     RCSTA2bits.CREN = 0;
@@ -198,7 +200,8 @@ void RS485_Interrupt_Tx(void)
         /* enable the receiver */
         RS485_TX_ENABLE = 0;
         RS485_RX_DISABLE = 0;
-        while (!TXSTA2bits.TRMT);
+        /* FIXME: might not be necessary
+ */
         PIE3bits.RC2IE = 1;
         RCSTA2bits.CREN = 1;
     }
@@ -346,7 +349,7 @@ void RS485_Disable_Port(void)
 
 void RS485_Reinit(void)
 {
-    RCSTA2 &= 0x4F;             /* Disable the receiver */
+    RS485_Set_Baud_Rate(38400);
 }
 
 /****************************************************************************